Innovate-motorsports MTX-L Quick Start Guide Manual do Utilizador descarregar pdf

MTX-L Accessories:

 4 pin to 2.5mm daisy chain cable: #3812

 4 pin to 4 pin daisy-chain cable: #3846

 Exhaust Clamp: #3728

 Stainless Steel Bung w/ Steel Plug” #3838

 HBX-1: Heat-sinking Bung Extender: #3729

 18ft sensor cable: #3828

Replacement Parts:

 Bung/Plug set: #3764

 Sensor (Bosch LSU4.2): #3737

 4 pin Serial Programming Cable: #3840

 8ft sensor cable: #3810

 3ft sensor cable: #3843

Order parts, get support, find FAQ answers, and read case

studies at www.tuneyourengine.com

Warning!

1) The Oxygen Sensor used with this device gets very hot in

operation. Do not touch the hot sensor. Do not let a hot sensor

touch a combustible surface. Do not use the sensor with or near

flammable liquids or gases. Failure to heed these warnings may

result in severe burns, explosions or fires. 2) When installed in the

exhaust, the oxygen sensor MUST be connected and operating with

the MTX-L whenever the car is running. An un-powered oxygen

sensor will be quickly damaged when exposed to hot exhaust gases.

MTX-L (Digital Air/Fuel Ratio Gauge)

QUICK START GUIDE

The complete instruction manual is on the CD

Warning!

1) The Oxygen Sensor used with this device gets very hot in operation. Do not touch

the hot sensor or let a hot sensor touch a combustible surface. 2) When installed in

the exhaust, the oxygen sensor MUST be connected and operating with the MTX-L

whenever the car is running. An un-powered oxygen sensor will be quickly damaged.

11-0129

1 2

MTX-L Accessories:  4 pin to 2.5mm daisy chain cable: #3812  4 pin to 4 pin daisy-chain cable: #3846  Exhaust Clamp: #3728  Stainless Steel

The complete instruction manual is on the CD MTX-L QUICK START GUIDE To gain access to the complete MTX-L manual please install the software provide

Sem comentários

Innovate-motorsports MTX-L Quick Start Guide Manual do Utilizador